Network Security, Critical Infrastructure Security, Government security

FAA suspends HPE Juniper router installations following ground stop

The Federal Aviation Administration has suspended the installation of HPE Juniper network routers as it investigates the cause of a nationwide ground stop that occurred last Friday, as first reported by CRN.

The disruption originated during a routine network upgrade in El Dorado, Arkansas, where a communications device intended to convert copper to fiber was installed. Transportation Secretary Sean Duffy stated that the device flooded the network, prompting the agency to pause further deployments of similar hardware.

While the FAA continues its review, Hewlett Packard Enterprise noted that its equipment appeared to function as configured. Industry experts suggest the issue may stem from a misconfiguration involving the device's multicast feature, which was incompatible with legacy Cisco routers still in use. The upgrade project is being managed by federal contractor L3Harris Technologies, which has completed over 70% of the transition from legacy copper to fiber.

The FBI is also involved in the investigation to rule out potential cyberattacks. The incident has raised questions regarding the timing of maintenance procedures, as the FAA typically performs critical infrastructure updates at night to minimize impact. The agency is now reevaluating its maintenance protocols to prevent future operational failures.

Source: CRN

An In-Depth Guide to Network Security

Get essential knowledge and practical strategies to fortify your network security.

You can skip this ad in 5 seconds